This are just some few of ours best selling whole house humidifiers.
We offer 1 Year warranty on BYPASS humidification products & 2 Years on SPRAY MIST humidifier.
Humidity is the water vapor within a given space. Relative Humidity simply is the amount of moisture in a cubic foot of air at a certain temperature. The warmer the air, the more moisture it can hold. A humidifier is a device that increases humidity in a single room or an entire building. In the home, whole-house humidifier is connect to a home’s HVAC system, provide humidity to the entire house.
The Aprilaire 500A will cover up to 3000 sq ft. Includes automatic digital control, outdoor sensor, water pad, 110V to 24V transformer, and biult-in bypass damper. The Aprilaire 500A will cover up to 3000 sq ft. This unit has a water feed rate of 3.0 GPH and will deliver an evaporative rate of .5 GPH Delivers optimum levels of humidity control with the Automatic Digital Humidifier Control.Provides vital service, temperature and relative humidity indicators in manual mode as well. Humidifies tightly constructed homes up to 3,000 square foot in size. Performs quietly with simple annual maintenance. Comes equipped with a drain to flush minerals from the unit. Incorporates easy right or left discharge change-over. Has an evaporation capacity of 0.50 gallons per hour.
Aprilaire Automatic Control Humidifier, 17 Gallons Per Day This Whole-House Humidifier featur truly automatic control, plus a built-in bypass damper, which means fewer parts to install. Delivers up to 50% more moisture in comparison to competitive units, Humidifies tightly-constructed homes up to 4,000 square feet in size. Automatic Digital Humidifier Control Built-In Bypass Damper with Handle Delivers Up to 50% More Moisture Vs. Competitive Units Evaporation at 0.70 Gallons Humidifies Up to 4,000 Square Feet Relative Humidity Indicators Test/Reset Button
Capable of handeling big humidification, the Aprilaire 700 Humidifier with digital control is perfect for large size homes. Alleviate many irritating health issues caused by dry, stale air. Designed to humidify up 4,200 square feet in tightly constructed homes,the Aprilaire 700 delivers up to 50 more moisture than competitively priced units. This humidifier also has an evaporation rate of .75 gallons per hour, one of the highest in the industry. Provides vital service, temperature and relative humidity indicators in manual mode as well. Performs quietly with simple annual maintenance. The Aprilaire 700 whole house Humidifier with automatic digital control can help you avoid expensive home repairs by providing the humidity consistently while reqiring little maintenance.
HUMID-A-MIST is a solid state humidification system that is incorporated into a forced air heating unit. HUMID-A-MIST is designed to maintain a broad range of humidity levels in a residential or commercial space by means of a bypass pulse board, a misting nozzle, water solenoid valve and a water filter cartridge. The pulse board is designed to pulse a mist of water at adjustable time intervals to accommodate a wide range of residential or commercial dwellings, according to the square footage and CFM requirements.
The ability to achieve and maintain humidity levels is controlled in three modes of the bypass pulse board and a separate gain switch incorporated into the pulse board.
In the unison mode both the furnace and HUMID-A-MISTwork together providing moisture to dry heated air.
* BYPASS MODE
In the event that humidity levels fall below humidistat setting and the heating system is not running due to satisfied space temperature, the bypass pulse board will bypass the heating circuit, powering the furnace in low speed and begin to pulse a mist of water to humidify space independently from normal operation of the furnace.
Should the HUMID-A-MIST be in the bypass mode and humidifying the space and the heating thermostat calls for heat, the bypass pulse board will sense a call for heat and go into standby mode, opening circuits to the furnace blower and water solenoid valve shutting down humidification so it will not interfere with normal start up or the efficiency of the heating cycle. Once furnace reaches required temperature and fan limit/logic board closes circuits to furnace fan, the bypass pulse board will come out of standby mode and return to unison mode and the humidification process will resume.
*THE GAIN SWITCH
The function of the gain switch is to turn on and off the bypass mode. In the on position the Hum-100 will operate independently from furnace at any time there is a call for heat. In the off position the HUMID-A-MIST will only operate on a call for heat.